QuickSpecs
Compaq ProLiant DL580
Standard Features
P r o c e s s o r | Intel Pentium III Xeon processor 700 MHz | |
| (Note: One or two processors ship standard depending on model.) | |
|
| |
Cache Memor y | ||
One of the following | ||
|
|
|
Upgrad abi li ty | Upgradable to quad processing |
|
| Support for future processor upgrades | |
|
|
|
Memor y | Standard | 512 MB |
| Maximum | 16 GB |
Note: Advanced ECC Memory Technology protects the data even in the event of an entire SDRAM component failure. Embedded in the chipset design, this feature allows the use of
Networ k Con trol ler | Integraged Compaq NC3134 Fast Ethernet NIC 64 PCI Dual Base 10/100 in a slot (upgradable to Gigabit) | |
|
|
|
Expan sion Slo ts | I/O (Total) | 6, 5 available |
| 2, 1 available | |
| 2, 2 available | |
| 1, 1 available | |
|
| |
| 1, 1 available | |
|
| |
|
| |
Stor age Con tro ll er | Integrated Smart Array Controller (supports Internal RAID 0, 1, 0+1, 5 and external tape devices) | |
| Note: The Integrated Smart Array Controller is embedded on the system board. | |
|
|
|
Stor age | Diskette Drives | 1.44 MB |
|
| High Speed IDE |
| Hard Drives | None |
| Maximum Internal Storage | 145.6 GB (4 x 36.4 GB 1″ drives) (internal hot plug drive cage) |
|
|
|
Interfaces | Parallel | 1 |
| Serial | 1 (Note: You can configure a second serial device to your ProLiant DL580 server |
|
| by installing the auxiliary serial connector that ships with the server. The auxiliary |
|
| connector attaches to a serial port B on the peripheral board and exits the rear of |
|
| the server through the auxiliary serial knockout located directly above the |
|
| redundant power feeds.) |
| Pointing Device (Mouse) | 1 |
| Graphics | 1 |
| Hot Plug Keyboard | 1 |
| External Wide Ultra2 SCSI | 1 |
| Network | 1 |
|
| |
Graphi cs | Integrated 1280 x 1024, 256 color on PCI local bus, | |
|
| |
Form Factor | Rack (4U = 7″ ), ships with sliding rails and cable management | |
|
|
|
Compaq So ftwar e | Compaq Insight Manager™ | The comprehensive system management tool that monitors the operation of |
|
| Compaq servers, workstations and clients |
| Compaq SmartStart™ | The server configuration and software integration tool from Compaq |
| Array Configuration Utility (ACU) | Same easy to use yet powerful graphical user interface (GUI) configuration utility |
| with Smart Array Controllers | and easy to navigate wizards for all Smart Array Controllers |
North America — Version 13 — December 18, 2000 | 2 |