Source Technologies STM.117W specifications Battery charging, Battery charger usage

Page 5

3-3 Battery charging

Lamp

1.Be sure that the printer is turned off

2.After open the DC JACK cover, insert DC JACK into the printer.

3.Plug the power code to electrical outlet.

3-3-1 The status of lamp in charging

Status

charging

charging complete

Charging Lamp

Red

Green

 

 

 

NOTE

1.Unless the exclusive charger is used provided by the manufacturer, the printer can be damaged, and the manufacturer is not liable for the consequential damage.

2.Before removing the battery, make sure that power is turned off.

3.Printer does not work in the status of being connected with charger only.

4.The battery should be installed to operate printer.

5.While charging, do not turn on the power.

6.Do not operate the print while charging the battery.

7.Do not connect the charger while the printer is operated.

3-4 Battery charger usage

Optional

Lamp

DC Jack

1.Insert the battery into the battery holder as shown above

2.Connect the DC JACK to the power electrical outlet.

3.Plug the power code into the electrical outlet.

4.Once the charging is completed, remove the battery from the holder.

3-4-1 The status of lamp in charging

Status

charging

charging complete

Charging Lamp

Red

Green

 

 

 

NOTE

In the case the battery is not fixed properly in the holder, the red lamp will be blinking, Then, extract and reinsert the battery.

6

7

Image 5
Contents Model STm.117w Table of Contents Product overview UnpackingControl panel usage Usage and InstallationBattery charger usage Battery chargingUsage of Cigar Jack Charger for charging Roll Paper installationSelf Test Leather case usagePeripherals connection Wifi802.11b/g ConnectionInterface Cable Connection Printer cleaningSpecification Pritner SpecificationCpcl Command Compatibility FCC Information CertificationPlease refer to the programming manual included in CD Setting up the software