2.2 Installation Procedures
2.2.1Connecting the power cord
Be sure to always handle the power cords by holding the plug ends only. Follow these steps to connect the power cord:
1.Connect the female end of the power cord to the AC inlet of the panel PC.
2.Connect the
Figure 2.4: Connecting the power cord
2.2.2Connecting the keyboard and mouse
1.Connect the
2.Connect the PS/2 mouse and keyboard to the
If you use a serial mouse, you can connect the mouse to any COM port in the I/O section.
2.2.3Switching on the power
Press the power switch on the front of the PC.
12 |