5Install the ATA drive in the U-shaped bracket.
Note: The tinted screws illustrated below indicate the four
These two tabs will
bend inward as you tighten these two screws.
Attach an additional ATA drive (1" high) to the upper portion of the drive carrier by screwing it into position on its sides. Attach the two screws on this side first.
ATA drives that are 1" high are attached to the lower portion of the drive carrier from the bottom.
Position the hard disk drive on the drive carrier so that the ribbon cable connector and the power cord connector are accessible.
If you’re installing a drive in the lower part of the
60 Chapter 4