USB eModule Error Messages
Message Displayed | Description |
|
|
Warning! | This message is displayed when a |
Unsupported USB | disabled by the BIOS. |
device found and |
|
disabled! |
|
|
|
Warning! Port 60h/ | This message is displayed to indicate that port 60h/64h emulation mode cannot be |
64h emulation is not | enabled for this USB host controller. This condition occurs if USB KBC emulation |
supported by this | option is set for |
USB Host Controller! |
|
|
|
Warning! EHCI | This message is displayed to indicate that EHCI controller is disabled because of |
controller disabled. It | incorrect data structure. This condition occur if the USB host controller needs |
requires 64bit data | data structure while the USB is ported with |
support in the BIOS. |
|
|
|
SMBIOS eModule Error Messages
Message Displayed | Description |
|
|
Not enough space in | This message is displayed when the size of the SMBIOS data exceeds the |
Runtime area!!. | available SMBIOS runtime storage size. |
SMBIOS data will not |
|
be available. |
|
|
|
CPU eModule Error Messages
Message Displayed | Description |
|
|
Warning! This system | This message is displayed when the power requirements of the board do not match |
board does not | the power requirement of the CPU. |
support the power |
|
requirements of the |
|
installed processor. |
|
The processor will be |
|
run at a reduced |
|
frequency, which will |
|
impact system |
|
performance. |
|
|
|
MPS Table (Multi-processor) eModule Error Messages
Message Displayed | Description |
|
|
Insufficient Runtime | This message is displayed when there is not enough space in the 0F000h runtime |
space for MPS data! | area for creating MPS table. |
System may operate |
|
in PIC or |
|
mode. |
|
|
|
Chapter 4 | 63 |