(1) | Power Cord | Attach the monitor to the power cord which should then be | |
inserted into a properly grounded electric socket. | |||
|
| ||
|
|
| |
(2) | VGA Cable | Connect the signal cable to the VGA output socket of the graphics card | |
|
| on the computer. Then tighten the thumbscrews on the connector | |
|
|
| |
(3) | DVI Cable (option) | Connect the signal cable to the DVI output socket of the graphics card | |
|
| on the computer. Then tighten the thumbscrews on the connector | |
|
|
| |
|
|
| |
|
|
|
WARNING: The
Operating Your Monitor
First, switch the power on to the monitor, then switch the power on to the computer. When you see the LED on the power button go green, this indicates the computer is ready for use. Allow about 10 seconds for the video signal to appear. If you do not see the green light on the power button or a video signal, check the connections .
|
|
| If OSD is active, press to exit. If OSD is inactive, press and the |
1 | AUTO | Auto Configuration | monitor will automatically optimize the display position, clock and |
|
|
| phase of your display. |
|
|
|
|
2 |
| Minus | If OSD is active, press to select or adjust OSD options. |
|
|
|
|
|
| Plus | If OSD is active, press to select or adjust OSD options. |
|
|
|
|
4 | MENU | OSD Menu | Press to view OSD. Press AUTO to exit. |
|
|
|
|
|
| Power | Power on/off |
|
| Green: power on | |
|
|
| Orange: in sleep mode |
|
|
|
|
|
|
|
|
OSD Options
Please refer to "External Controls " on Page 5. To adjust the OSD settings :
1.Press the MENU button to open the OSD menu.
2.Use the buttons marked < or >, to highlight a control, then press the MENU button to enter
3.Use the buttons marked < or >, to adjust the control to the desired level.
4.When you have finished making all selections, press the MENU button to exit the OSD. (Or the adjustment will