Acer M5200, M3200, M1200 manual Pci/Vga, PCI 1/2 IRQ

The following table describes the parameters found in this menu.

Parameter	Description	Options
Init Display	Initialize the AGP video display before initializing
First	any other display device on the system. Thus the
	AGP display becomes the primary display.
Reset	Normally, you leave this field Disabled. Select	[Enabled],
Configuration	Enabled to reset Extended System Configuration	[Disabled]
Data	Data (ESCD) when you exit Setup if you have
	installed a new add-on and the system
	reconfiguration has caused such a serious conflict
	that the operating system cannot boot
Resources	This item allows user to assign PnP resource (I/O	[Auto]
Controlled By	address, IRQ&DMA channels) for Plug and Play	[Manual]
	compatible devices automatically or manually
IRQ Resources	When resource are controlled by manually, assign	[Press Enter]
	each system interrupt a type , depending on the type
	of device using the interrupt.
	Option:
	[PCI Device]: Assign this IRQ for PCI device.
	[Reserved]: Reserve this IRQ for other device.
PCI/VGA	This option is only very rarely needed. It should be	[Disabled],
Palette Snoop	left at “Disabled” unless a video device specifically	[Enabled]
	requires the setting enabled upon installation.
Maximum	This field displays maximum payload size of the	[128-4096]
Payload Size	system
PCI 1/2 IRQ	This item allows user to assign PCI IRQ for device	[Auto], [3] ,
Assignment		[4] , [5] , [6] ,
		[7], [10] ,
		[11] , [12] ,
		[14] , [15]

42