EAW MK8126 specifications Dimensional Drawing, Specifications, Front Right Side, Back, Bottom

DIMENSIONAL DRAWING

11.75
GRILLE
PARTIALLY	2.90		5.25	.97
SHOWN		INPUT	C
			L
	(1.95)
				9.09
		10.09		7.25
		10.21
19.75	15.85
				5.00

FRONT	RIGHT SIDE		2.75
	DIMENSIONS APPLY		BACK
45°	TO BOTH SIDES
8.07
C
L
4.08	2.90		NOTES
	5.90
		1. SYMBOL INDICATES MOUNTING POINT,
	11.03		3/8-16 THREADED HOLE (PI ANGLE).
		2. SYMBOL INDICATES MOUNTING POINT,
			5/16-18 THREADED HOLE (OMNI MOUNT).
		3. SYMBOL INDICATES MOUNTING POINT,
			3/8-16 THREADED HOLE (RIVNUT).
(6.00)
BOTTOM
DIMENSIONS APPLY TO			509180 (1) 9/17/02
TOP AND BOTTOM

Manufacturing tolerances are +/- 0.13 and +/- 1°

SPECIFICATIONS MK8126

A & E SPECIFICATIONS

The two-way full range loudspeaker systems shall incorporate an 8-in LF transducers and a 1-in exit/1.5-in voice coil com- pression driver HF transducer.

The LF drivers shall be mounted in an optimally vented enclo- sure tuned for maximum low frequency response. The HF driv- er shall be loaded on a constant directivity horn with a nom- inal coverage pattern of 120° (h) x 60° (v). The HF horn shall feature a square flange allowing it to be rotated 90°. An internal passive filter network shall provide fourth order acoustical crossover and system equalization between the low and high frequency sections.

System frequency response shall vary no more than ±3 dB from 89 Hz to 18 kHz measured on axis. The system shall pro- duce a Sound Pressure Level (SPL) of 95 dB SPL on axis at 1 meter with a power input of 1 Watt, and shall be capable of producing a peak output of 125.8 dB SPL on axis at 1 meter. The system shall handle 300 Watts of amplifier power (AES Standard) and shall have a nominal impedance of 8 Ohms.

The loudspeaker enclosure shall be trapezoidal in shape. It shall be constructed of exterior grade Baltic birch plywood and shall employ extensive internal bracing. It shall be fin- ished in wear resistant textured black paint. Input connectors shall be two-terminal barrier strip. A total of 13x 3/8"-16 threaded mounting/suspension points (3 each top and bot- tom, 3 per side and 1 back) shall be provided. Four addition- al mounting points shall be provided on the rear configured to accept an Omnimount brand Series 100 bracket. The front of the loudspeaker shall be covered with a powder coated per- forated steel grille.

The 2-way full range loudspeaker shall be the EAW model MK8126.

One Main Street, Whitinsville, MA 01588	508 234 6158	Toll Free 800 992 5013	FAX 508 234 8251	info@eaw. com	www. eaw. com
EAW products are continually improved. All specifications are therefore subject to change without notice.			MK8126/0004843/001/2 pp	September 2002	Printed in USA