Keyboard Wedge non direct power | Datalogic Scanning DLL2020-WO

18	Installing the DLL2020-WO

D)Keyboard Wedge non direct power

For those systems which do not supply electrical power on the keyboard port, the following set-up is applicable.

Plug the cable with the 10-pin modular jack into the scanner port until a firm ‘click’ is heard.

Plug the other connector into the splitter box as illustrated in the figure below. Plug the communication cable with the 8-pin modular jack into the Keyboard Wedge port of the splitter box. Connect the female connector at the other end of the cable to the keyboard. Plug the male connector into the keyboard port of your computer. Connect the Datalogic power supply unit to the power supply port of the splitter box. Power on the scanner by connecting the IEC power cord to the AC/DC power supply and by plugging the AC power cord into an AC outlet.

Keyboard Wedge non direct power

DLL2020-WO

Cable

Computer

	Splitter box
		To computer
To AC	KBW
Power outlet
	Communication
Power supply	cable	To keyboard

Once the scanner has been installed, you can start scanning bar code labels.

If you want to change the default settings of the scanner, proceed to the Configuration Guide supplied with the scanner.