Appendix a Troubleshooting | Honeywell HEMS II guide

Appendix A

Troubleshooting

Appendix A:

Troubleshooting

Your computer cannot connect to the Internet.

Follow these instructions until your computer can connect to the Internet:

•• Make sure that the Router is powered on.. The Power LED should be green and not flashing..

•• If the Power LED is flashing, then power off all of your network devices, including the modem, Router, and computers.. Then power on each device in the following order:

1.Cable or DSL modem

2.Router

3.Computer

•• Check the cable connections.. The computer should be connected to one of the ports numbered 1-4 on the Router, and the modem must be connected to the Internet port on the Router..

The modem does not have an Ethernet port.

The modem is a dial-up modem for traditional dial-up service.. To use the Router, you need a cable/DSL modem and high-speed Internet connection..

You cannot use the DSL service to connect manually to the Internet.

After you have installed the Router, it will automatically connect to your Internet Service Provider (ISP), so you no longer need to connect manually..

The DSL telephone line does not fit into the Router’s Internet port.

The Router does not replace your modem.. You still need your DSL modem in order to use the Router.. Connect the telephone line to the DSL modem, insert the setup CD into your computer, and then follow the on‑screen instructions..

When you double-click the web browser, you are prompted for a username and password. If you want to get rid of the prompt, follow these instructions.

Launch the web browser and perform the following steps (these steps are specific to Internet Explorer but are similar for other browsers):

1.Select Tools > Internet Options..

2.Click the Connections tab..

3.Select Never dial a connection..

4.Click OK..

The Router does not have a coaxial port for the cable connection.

The Router does not replace your modem.. You still need your cable modem in order to use the Router.. Connect your cable connection to the cable modem, insert the setup CD into your computer, and then follow the on‑screen instructions..

You need to modify the settings on the Router.

Open the web browser (for example, Internet Explorer or Firefox), and enter the Router’s IP address in the address field (the default IP address is 192.168.1.1).. When prompted, leave the User name field blank and enter the password to the Router (the default is admin).. Click the appropriate tab to change the settings..

WEB: If your questions are not addressed here, refer to the Linksys website, www.linksys.com..

EtherFast Cable/DSL Router with 4-Port Switch