Control Panel Overview Continued
(6) Auto ON/OFF
When the main “POWER” ON/OFF switch is in the “OFF” position, this switch has no affect on the subwoofer. When the main “POWER ON/OFF” switch is in the “ON” position, this switch allows the auto circuit to be engaged. When this switch is in the “AUTO” position, the subwoofer will automatically turn “on” when it senses a signal. It will automatically turn “off” after 20 minutes with no signal. When this switch is in the “ON” position, the subwoofer will remain on as long as the “POWER” ON/OFF switch is in the “ON” position.
(7) 110-120V AC Power Connection
The Earthquake MiniMe is equipped with a built in standard,
(8) Power Status LED
Earthquake powered subwoofers have an LED on the panel that indicates the status of the
(9) 0-180° Phase Shift
This control is used to acoustically match the subwoofer’s output to your main speakers. Select the position, either 0° or 180°, in which your subwoofer has more output at the listening position.
(10) Sub Operation Switch
In LFE position, the Frequency adjustment becomes disabled and the subwoofer runs in a Full range mode, from 20Hz - 2kHz.
While in Sub position the subwoofer reverts to the manual frequency adjustment, allowing the user to operate and fine tune the subwoofer to their personal taste.
(11) 50Hz - 160Hz Frequency Adjustment
This controls the high frequency cutoff point. With the control set to the middle, the subwoofer will reproduce frequencies up to 105Hz. If the control is set fully clockwise, the crossover is bypassed and the subwoofer will reproduce a wide frequency range. With the control fully
Rotate the control until the bass sound natural. If the
(12) Volume Control
Manual volume control to regulate your subwoofers power output, to prevent clipping and distortions caused by overpowering.
Always unplug the power cord before inspecting or changing the fuse. Never use a fuse with a larger current rating than recommended.
Earthquake • MiniMe User Manual |
| 6 |
|