Index of Error Messages
Error Message List
Error Messages | FRU/Action in Sequence |
|
|
Struck Key | See “Keyboard or Auxiliary Input Device Check“. |
System CMOS checksum bad - | RTC battery |
Default configuration used | Run BIOS Setup Utility to reconfigure system, then |
| reboot system. |
|
|
Real time clock error | RTC battery |
| Run BIOS Setup Utility to reconfigure system time, then |
| reboot system. |
| Main board |
|
|
Previous boot incomplete - Default | “Load Default Settings” in BIOS Setup Utility. |
configuration used | RTC battery |
| Main board |
|
|
Invalid System Configuration Data | “Load Default Settings” in BIOS Setup Utility. |
| Main board |
|
|
Operating system not found | Enter Setup and see if fixed disk and drive A are |
| properly identified. |
| Diskette drive |
| Hard disk drive |
| Main board |
|
|
Power source (battery pack and power adapter.) See | |
is blank. | “Power System Check“. |
| Ensure every connector is connected tightly and |
| correctly. |
| Reconnect the DIMM. |
| Main board. |
|
|
Power source (battery pack and power adapter.) See | |
is blank. | “Power System Check“. |
| Reconnect the LCD connector |
| Hard disk drive |
| LCD cable |
| LCD inverter |
| LCD |
| Main board |
|
|
Reconnect the LCD connectors. | |
is blank. But you can see POST on an | LCD cable |
external CRT. | LCD inverter |
| LCD |
| Main board |
|
|
Ensure every connector is connected tightly and | |
blinking cursor shown on LCD during | correctly. |
POST. | Main board |
|
|
77 | Chapter 4 |