N G R a T U L a T I O N S | JL Audio SB-GM-SLVEXT2/10W1v2/TN

S T E P 4

Line up the Stealthbox® so that the seat belt anchor bolt is centered in the recess in the enclosure. Press down on the Stealthbox making and imprint in the 3” x 3” wax square with the Mounting Stud. Remove the Stealthox® and drill a 1/2” hole through the floor where the mark was made.

Before drilling, always make sure that you are not going to be drilling into any gas lines, brake lines, tires, transmission lines, electrical wiring, exhaust systems or anything else that might cause a reduction in your weekly pay.

Always wear eye protection when drilling!

S T E P 5

Back the Mounting Stud out of the Stealthbox® so that approximately 1-1/4” is exposed, set the Stealthbox® back into place, with the Mounting Stud going through the freshly drilled hole.

S T E P 6

Install the included Fender Washer, Split Lock Washer and Hex Nut as shown, tighten them down.

S T E P 7

C O N G R A T U L A T I O N S !

You have completed the installation for this model!

Enjoy your new Stealthbox®!

Please refer to the Power Recommendation section for an amplifier recommendation and basic set-up help.

SB-GM-SLVEXT2/10W1v2 INSTR_SKU# 011300

I N C L U D E D H A R D W A R E

1)	3/8-16 x ***” Mounting Stud	1)	3/8 x 1-1/4” Fender Washer
1)	3/8” Split Lock Washer	1)	3/8-16 Hex Nut

S P E C I F I C A T I O N S

Enclosure Type: Acoustic Suspension (sealed)

Driver Type: (2) 10W1v2-8

Nominal Impedance: 4 ohms

Continuous Power Handling: 600 watts

P o w e r R e c o m m e n d a t i o n

JL Audio recommends high quality amplifiers such as the JL Audio HD900/5, 500/1v2 or J2 500.1. The diagram below shows the recommended crossover, infrasonic filter and equalizer settings for the 500/1v2. If another amplifier is being used, please reference this illustration and use similar settings on that amplifier.

+12VDC Ground Remote

Preamp Output Section

Infrasonic Filter

“Q”

Center Freq. Boost (dB) Amp LP Filter

Amplifier Input Section

Subwoofer Output

Output Mode	Filter Slope			Mode		1.6		40	+10		Mode Slope		Input Voltage	Input Sens.	Signal Sensing
Output Mode	Filter Slope			Mode	1.1	2.7	30	60	+4	+13	Mode Slope		Input Voltage	Input Sens.	Signal Sensing
					0.7		25	75
Full Range Amp Filter Out Filter	12dB 24dB			Off On	0.5	4.3	20	80	0	+15	Off 12dB 24dB		Low High		Off On
		65	Filter Mode	30		Bass EQ						65
	55	80	Filter Mode	22	45	Bass EQ			Advanced		55	80
500/1v2									Advanced
500/1v2	45	100		18	55				Bass		45	100			MONO OUTPUT ONLY
Monoblock Subwoofer Amplifier	40	200	LP HP	15	60	Off On			Control		40	200			MONO OUTPUT ONLY

Left Output Right Output

Filter Freq. (Hz)

Infrasonic Freq. (Hz)

Remote Bass Port

Filter Freq. (Hz)

Left Ch.

Right Ch.

All JL Audio amplifiers are very versatile audio components. Please consult the owner’s manual for even more detailed information about installing and tuning your amplifier.

C o n n e c t i o n s

Using quality power, signal and speaker wire is essential in ensuring the performance of your Stealthbox®. JL Audio recommends using a 4 AWG power kit such as the XC-PCS4-1B for your Stealthbox® amplifier, other kits are available should you be using more than one amplifier. Signal wire such as the JL Audio Premium Audio Interconnect Cables should be used that will provide signal for both channels of the amplifier. JL Audio reccommends using 12AWG speaker wire for subwoofers such as our XC-BCS12-25.

M I D / H I G H F r e q u e n c y D r i v e r F I T M E N T

A variety of JL Audio coaxial and component systems will fit in the factory speaker locations of you vehicle.

Front Speaker Size / Location: 5”x 7” / 6”x 8”- Front Doors

Fits JL Audio Models: TR570-CXi, C2-570x, C3-570, C5-570, C5-570x & ZR570-CSi

Rear Speaker Size / Location: 5”x 7” / 6”x 8”- Rear Door

Fits JL Audio Models: TR570-CXi, C2-570x, C3-570, C5-570, C5-570x & ZR570-CSi

(954)443-1100www.jlaudio.com

All specifications are subject to change without notice. “JL Audio®” and the JL Audio logo, “Stealthbox” and the Stealthbox logo are registered trademarks of JL Audio, Inc. “Ahead of the Curve” and its respective logo is a trademark of JL Audio, Inc.

JLA-SKU# ******** **-**-2009 • Printed in USA • ©2008 JL Audio, Inc. • U.S. PATENTS: #5,734,734 #5,949,898 #6,118,884 #6,229,902 #6,243,479 #6,294,959 #6,501,844 #6,496,590 #6,441,685 #5,687,247 #6,219,431 #6,625,292 #D472,891 #D480,709 Other U.S. & Foreign patents pending. For more detailed information please visit us online at www.jlaudio.com.

Page 2 • JL Audio, Inc 2009

1 0 3 6 9 N O R T H C O M M E R C E P A R K W A Y • M I R A M A R , F L O R I D A • 3 3 0 2 5 • U S A

SB-GM-SLVEXT2/10W1v2/GA, ZR570-CSi, SB-GM-SLVEXT2/10W1v2/GA2, SB-GM-SLVEXT2/10W1v2, SB-GM-SLVEXT2/10W1v2/TN specifications

JL Audio is a renowned name in the audio industry, consistently delivering high-quality sound solutions to automotive enthusiasts. Among their impressive lineup, the C5-570x speakers and the SB-GM-SLVEXT2 subwoofer enclosure options, featuring the 10W1v2 subwoofer, stand out for their performance and innovative technologies.

The C5-570x is a premium component speaker set designed for those seeking unparalleled audio fidelity in their vehicles. It boasts a 5x7-inch woofer, manufactured with a mineral-filled polypropylene cone, which ensures excellent mid-bass response and durability. The butyl rubber surround provides enhanced linearity and resilience, allowing the speakers to deliver clean sound at various volume levels. The silk dome tweeter offers smooth high-frequency reproduction, ensuring a balanced sound stage. Furthermore, the C5-570x features a bi-ampable design with a built-in crossover, allowing for the option to drive woofers and tweeters separately for improved sound clarity.

JL Audio’s SB-GM-SLVEXT2 subwoofer enclosures are designed specifically for select General Motors vehicles, integrating seamlessly with the vehicle’s interior while delivering impressive bass performance. The models SB-GM-SLVEXT2/10W1v2/DG, SB-GM-SLVEXT2/10W1v2/TN, SB-GM-SLVEXT2/10W1v2, and SB-GM-SLVEXT2/10W1v2/GA2 highlight the versatility and depth of choices available to consumers. These enclosures are crafted from high-quality MDF, ensuring optimal sound performance and low distortion.

The heart of these enclosures is the 10W1v2 subwoofer, featuring a compliant, yet durable, cone design that delivers powerful bass without sacrificing clarity. The subwoofer utilizes advanced technologies such as DMA-optimized motor designs and high-temperature voice coils, allowing it to handle significant power while maintaining reliability. This combination of features results in deep, impactful bass, making it an ideal choice for performance-oriented audio setups.

In conclusion, the JL Audio C5-570x speakers and SB-GM-SLVEXT2/10W1v2 subwoofer enclosures exemplify quality, performance, and innovative engineering. Whether upgrading existing audio systems or building a new one, these products offer sound enthusiasts and car audio lovers an opportunity to experience their favorite tracks with unprecedented clarity and depth. With a commitment to excellence and a focus on performance, JL Audio continues to set the standard in the automotive audio landscape.