Installing the paper rolls. |
| |
1. | Each spring bar assembly is designed to hold a | Paper Roll Retainers |
| full roll of paper. Select either spring bar for |
|
| installation of a new roll of paper. |
|
2. | Remove the wing nuts on both sides of the |
|
| spring bar assembly, and place the assembly on |
|
| your workbench for installation of the paper. |
|
3. | Loosen the screws in one or both of the retainer |
|
| sets, and slide them off the spring bar. |
|
4. | Slide a paper roll onto the spring bar, abutting |
|
| the remaining retainer set. The paper roll should |
|
be positioned so that when the spring bar as-
Paper Reel on Spring Bar Detail
sembly is reinstalled onto the masking station the paper will pull off the top of the roll toward the cutting blades.
5.Slide the retainers back onto the spring bar assembly, and replace the assembly back onto the masking station.
6.Retighten the screws in the retainers to hold the paper roll firmly in position.
7.If desired, you may align the paper with the edges of the tape rolls. To do so, loosen the screws in both sets of retainers, and slide them with the paper roll along the spring bar until the edges of the paper roll is aligned with the center of the tape rolls. Tighten the screws in the paper retainers to secure this position on the spring bar.
Upper Paper Roll
Threading the Paper and Tape through the
Cutting Blades.
| NOTE: The upper tape rolls and upper |
|
| |
paper roll will feed through the upper cutting |
| Upper Cutting Blade | ||
blade. The lower paper roll and lower tape rolls |
| |||
|
| |||
will thread through the lower cutting blade. |
|
| ||
1. | Pull out the paper from the roll, and pass | Upper | Paper / Tape Paths | |
Tape | ||||
| ||||
| it behind the cutting blade, under the | Rolls |
| |
| spring, over the cutting edge, and out to |
| Lower Cutting Blade | |
| the front of the masking station. |
| ||
|
|
| ||
2. | Repeat step 1 with each roll of tape. If |
|
| |
| you have aligned the tape with the edge | Lower |
| |
| of the paper, attach the tape to the paper, |
| ||
| and pull the paper / tape combination | Paper | Lower Tape Rolls | |
| through the spring and out to the front of | Roll |
| |
the masking station. Note that the spring holds the leading edge of the materials onto the cutting bar, and also rubs the
tape onto the paper just before cutting.
Figure 7. Paper and Tape Path
SKU 45146 | For technical questions, please call | Page 7 |