Bogen ANS501 Sensor Microphone Connections, Sensor Microphone Wiring, Wiring Multiple Microphones

Page 6

Sensor Microphone Connections

Sensor Microphone Wiring

The ANS501 requires connection of at least one sensor microphone for operation.To allow for better ambient noise sensing of large areas, up to 4 sensor microphones can be connected to a single ANS501.

All microphones are wired in parallel matching the polarity markings on the sensor mic with the marking of the two MIC terminals on the ANS501.

Wire runs between the control unit and microphones consist of two-conductor cable and can reach 2,000 feet (with 20AWG wire) with no appreciable loss of signal strength.

Wiring Details

ANS501 & Microphones

To Other Microphones

(4 Total)

Wiring Multiple Microphones

Physical connections can be made using either Home Runs back to the ANS501 from each sensor mic or by daisy- chaining sensor mics, depending on the installation.The maximum total wire length from any sensor mic to the ANS501 must be kept below 2000 ft.

Daisy Chain Style Wiring

Home Run Style Wiring

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Total Max Wire Length 2000 ft.

Max Run Length 2000 ft.

(Each Run)

6

Image 6
Contents Ambient Noise Sensor Model ANS501 Important Safety Information Domestic and International ListingsContents Features DescriptionPanel Descriptions Sensor Microphone Wiring Wiring Multiple MicrophonesSensor Microphone Connections Front Panel Switches and Indicators OperationFront Panel Controls Operation, ConnectionsModule Setup Bypass ModeModule Setup, Normal ModeBypass Mode Illustration Normal Mode Illustration Ambient Level Settings SpecificationsBlock Diagram Limited Warranty Spring Street, Ramsey, NJ 07446, U.S.A