Premier Mounts PDS-023 installation instructions

PDS-023 Projector Bracket

PDS-023 Projector Bracket Installation Instructions

	M4 x 10mm Phillips
	Head Screws
PDS-023 Bracket	(Qty 3)
(Qty 1)	M4 x 10mm
	Security Head
	Screws (Qty 3)

Premier Mounts

3130 E. Miraloma Ave.

Anaheim, CA 92806

Phone: (800) 368-9700 Fax: (800) 832-4888 techsupport@mounts.com www.mounts.com

1.Invert the projector and place it on a soft and flat surface. Remove any foot levelers that might possibly prevent the correct installation of the bracket.

2.Locate the three mounting points located on the bottom of the projector.

3.Line up the mounting points on the projector with the mounting holes on the PDS-023 mounting bracket.

1.Using a screwdriver, secure the PDS-023 mounting bracket using three (3) M4 x 10mm Phillips Head screws. Do not over tighten these screws. Overtightening the screws may result in damaging the threaded inserts on

the projector.

NOTE: Please refer to the PDS Base Box Installation Instructions to attach the PDS Base Box to the PDS-023 mounting bracket.

NOTE: The projector (shown above) is for illustration purposes only.

Installation Instructions Page 1

IN-PDS023.R0