Mounting Bracket

Using the enclosed template, mark your desired speaker location.

NOTE: the bracket is offset to allow for the slide mount of the speaker onto the bracket.

The offset allows the speaker to be centered when mounting is complete. If mounting in a stud-less drywall location, use the enclosed self-tapping drywall augers and screws. Start the auger in the drywall location with a few slight taps from a hammer, then screw down snugly with a screwdriver. To mount the bracket, hold the bracket in the desired location and fasten with the included screws. If you’re mounting the bracket to surfaces other than drywall or hardwood, we recommend you consult with a hardware or construction professional to obtain the best hardware for your application. RBH recommends the use of the bubble-type level to ensure correct positioning of your speakers.

Four arrows in the picture point to four screw holes which should be used to attach

the bracket to your mounting surface. The elongated center hole in the bracket is

designed to allow the speaker wire to pass

through. The keyways indicated by the other two arrows show the locations where the speaker mounting knobs will be inserted into the bracket.

TIP: Prior to actually mounting your speaker, you may want to assemble the mounting knobs and bracket to the speaker to gain a better understanding of how the pieces work together.

NOTE: When mounting in a vertical position, the speaker should always slide down onto the bracket.