Premier Mounts PDS-009 Lock-It, Security System, Mounting Bracket Security Screws

LOCK-IT™ Security System

LOCK-IT™

Security System

Premier Mounts

3130 E. Miraloma Ave.

Anaheim, CA 92806

Phone: (800) 368-9700 Fax: (800) 832-4888 techsupport@mounts.com www.mounts.com

NOTE: To utilize the LOCK-IT™ Security System, all M6 x 12mm Phillips Pan Head screws (A) must be removed prior to installing the M6 x 12mm Security Screws (D).

1.Remove all pre-installed M6 x 12mm Phillips Pan Head screws (A - 6 total).

2.Use the M5 Security Wrench (B - supplied) to install and tighten the M6 x 12mm Security Screws (D).

3.Using the security wrench (supplied), remove the M6 x 8mm standard set screw and replace it with the M6 x 8mm security set screw (C).

4.Insert the nylon washer (G), 1/4” flat washer (H) and the M6 x 12mm Security Screw (D) into the pivot point (I).

5.Attach bracket to projector using security screws.

6.Once the Phillips Pan Head screws have been replaced with the security screws, re-attach the bracket (E) to the mount (F).

7.Insert the four tilt adjustment security screws (two per side).

8.Follow the instructions in the PDS Manual to complete the installation.

Mounting Bracket Security Screws

1.Using a security wrench (supplied), secure the PDS-009 mounting bracket using four (4) M6 x 10mm Security Head screws. Do not over tighten these screws. Overtightening the screws may result in damaging the threaded inserts on the projector.

Page 2 Installation Instructions