Sanyo LNS-T02K, LNS-W02K manual Fig-2, Fig-3, Remove the Lens Cover, Case of Model Without Lens

LENS REPLACEMENT AND INSTALLATION PROCEDURE

Perform the steps

1

to

5 for lens replacement and installation.

First, set the lens at the center position with lens shift button.

1 REMOVE THE LENS COVER.

First check the shape of cabinet.

In case figure-1 cabinet.

1.Remove screws A (2 screws).

2.Pull down the lower lens cover while pushing the part D, then remove it.

3.Remove screws B (2 screws).

4.Remove screws C (2 screws) and remove upper lens cover.

UPPER LENS COVER C

B

D

D	Fig-1
A	LOWER LENS COVER

LENS COVER

In case figure-2 cabinet.

Remove 4 screws of the lens cover and remove the lens cover.

2

●IN CASE OF MODEL WITHOUT LENS

REMOVE THE COVER PLATE OF THE LENS COVER. (See figure-3)

Fig-2

Remove 2 screws and pull down the plate.

(At the step 5 , insert the light-block sheet in the same position as the removed cover plate has been placed. Two screws are not used.)

Use the light-block sheet included with lens.

Set the light-block sheet, so that the large rounder side is set over the lens.

SCREWS

COVER PLATE

Fig-3

LIGHT-BLOCK SHEET