Dell S520 manual Attach sensor cover by snapping clips over screen frame

Page 10

Installation (continued)

 

DC Power

20. Attach sensor cover by snapping clips over screen frame.

Cable for

Sensor

Secure to frame by screwing down into the upper channel of

 

 

the screen frame with supplied #8 x 3/4” screw (Figure 12).

 

 

 

 

21. In between the projector mount and the IR sensor cover, cable clips will be mounted to the wall for cable management. Attach clips to the wall using:

Wood studs: (4) supplied #8 x 1” screws.

Concrete wall or no studs: (4) supplied #8-10 wall anchors and (4) supplied #8 x 1” screws.

When secure, route cables and cords behind the two cable clips. Attach cable cover to the cable clips (Figure 13).

NOTE: Two cable clips are shipped with the screen/

 

 

Figure 12

whiteboard. For some installations, only one cable clip may

be needed.

 

 

22. Install projector mount covers and projector (Figure 14). Refer to the S520 Dual Stud Wall Mount (MSP-DCCUST1) manual.

Figure 13

Figure 14

10

Image 10
Contents Ptdrv Important Safety Instructions Product Dimensions Front ViewTools Required for Installation PartsInstallation Installation IR Sensor Power Projector Signal Cable Projector Power Cord Installation Page Attach sensor cover by snapping clips over screen frame Recommended Screen/Whiteboard Cleaning Recommended Screen/Whiteboard MarkersInstallation Video