NOTE:
∙This equipment has been tested and found to comply with the limits for a Class B digital device pursuant to Part 15 of the FCC Guidelines.
∙The products are designed to provide reasonable protection against harmful interference in a residential/commercial installation and end user application and may radiate radio frequency energy.
∙However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
1.The power outlet should be close to the unit and easily accessible.
2.
3.Increase the separation between the equipment and the receiver.
4.Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
5.Consult the dealer or an experienced radio/TV technician for additional help.
SCREEN OPERATION
Setup: Remove the controls and wiring from the compartment on the left side of the Kestrel Floor Electric Screen as shown in the pictures below.
Connect the screen to the power supply and switch the po wer button on . Now it is ready for use .
Power:
ONOFF
About the Control System:
1.
2.IR (Infrared) and RF (Radio Frequency): The Kestrel Series screen includes both IR and RF receivers that enable the consumer to use either the IR remote control with direct line of sight through the screen’s IR receiver window. The RF remote is best used when the screen is concealed or long distance control is required. The RF technology therefore does not require line of sight directly to the screen’s IR receiver window.
2