Installation
NOTE: Prolonged storage of the Insta‐DEM in its factory packaging may result in the material not being able to lie flat once removed from its tube. An easy way to remedy this is to remove the material from the tube and roll it up in a reverse manner for 5 minutes. This will flatten out the material and make it more pliable to work with.
1.Clean the magnetic surface location where the Insta‐DEM Screen will be installed.
2.Measure and mark the top‐right and bottom‐right corner of the installation location.
Magnetic surface
Wall
3.Attach the Insta‐DEM Screen to the top‐right and bottom‐right corner of the installation location.
Magnetic Surface
4.Carefully unroll the material and firmly attach the top and bottom until the Insta‐DEM Screen is completely attached.
3
Rev.040611‐AS | info@elitescreens.com |
www.elitescreens.com |