PMK 155 Installation Guide | Extron electronic instruction

PMK 155 • Installation Guide

The Extron® PMK 155 Pole Mount Kit is a simple solution for mounting Extron devices and their external power supplies to a projector pole. The PMK can be installed on a 1.5-inch pipe within a 4-inch space between the projector and the ceiling.

Including the power supply, the following devices can be mounted:

zz one three-inch deep half-rack device, or
zz	one six-inch deep half-rack device, or
zz	two three-inch deep quarter rack devices,	Mounting Plate
	or

zz an MPA 401

Pipe Clamp

ATTENTION: The maximum load for the PMK 155 is 5 lbs (2.25 kg).

NOTE: The PMK 155 is to be used only with Extron UL listed products.

(2) Hex Bolts (2) Washers

(2) Tie Wraps

Installation

NOTE: Ensure the finished installation is in accordance with local and national buildng

codes, fire and safety codes, UL requirements, and local and national electrical codes.

To install the PMK 155 (with a device) on a projector pole:

1.Place the plate on the base of the device and align holes in the plate with the mounting holes in the device.

Use 2 mounting holes on opposite corners.

(2) 4-40 x 3/16" Screws

2.Secure the device to the plate with 4-40 screws.

ATTENTION: Use only the screws supplied with the device to avoid damaging it.