Sun Microsystems 4000 manual Getting Help for Commands, VcaadmvcaN@hostname, secofficer set ?

Getting Help for Commands

vcaadm has built-in help functions. To get help, you must enter a question mark (?) character following the command you want more help on. If an entire command is entered and a “?” exists anywhere on the line, you will get the syntax for the command, for example:

vcaadm{vcaN@hostname, sec_officer}> create ?

Sub-Command	Description
-----------------------------------------------------
so	Create a new security officer
user	Create a new user
vcaadm{vcaN@hostname, sec_officer}> create user ?
Usage: create user [<username>]
vcaadm{vcaN@hostname, sec_officer}> set ?
Sub-Command	Description
-----------------------------------------------------
passreq	Set password requirements
password	Change an existing security officer password
timeout	Set the auto-logout time

You can also enter a question mark at the vcaadm prompt to see a list of all of the vcaadm commands and their description, for example:

vcaadm{vcaN@hostname, sec_officer}> ?
Sub-Command	Description
-----------------------------------------------------
backup	Backup master key
connect	Begin admin session with firmware
create	Create users and accounts
delete	Delete users and accounts
diagnostics	Run diagnostic tests
disable	Disable a user
enable	Enable a user
exit	Exit vcaadm
loadfw	Load new firmware
logout	Logout current session
quit	Exit vcaadm
rekey	Generate new system keys
reset	Reset the hardware
set	Set operating parameters
show	Show system settings
zeroize	Delete all keys and reset board

64 Sun Crypto Accelerator 4000 Board Installation and User’s Guide • May 2003