UNINET IMAGING INC. • BROTHER 1240/1650 • ASSEMBLING THE OPC CARTRIDGE
1.Replace the transfer roller together with its saddles and the helical gear.
3.Slide the axle from left to right, insert the bearing in place and the retaining washer to secure the axle in place.
2.Replace the OPC drum by mounting the clutch and spring on the right side and engage the drive gear on the left. NOTE: Before insert- ing the axle lift the spring loaded contact wire located between the drive gear of the OPC and the side of the cartridge.
4.Insert the drum cleaning assembly and with a Phillips screwdriver and tighten the screws to secure it to the cartridge. The screw on the left will pressure the contact between the assembly and the drum axle.
www.uninetimaging.com
USA
Ph:
Fx:
EUROPE
JAPAN
BRAZIL
ARGENTINA
11124 Washington Blvd., Culver City, California U.S.A. 90232 Ph: 310
© 2005 Uninet Imaging Inc. All Trademark names are property of their respective owners. Product brand names mentioned are intended to show compatibility only. Uninet Imaging does not guarantee or warrant downloaded information.