Preparations
1 Installing the recording paper and stacker
Recording Paper
IncorrectSlack
Push up to open the cover.
2 Connections
Raise the antenna.
Stacker
Close the cover. 
Approx.
15 cm
click | To Power | Connect to “回線 ” (line). |
| Outlet | |
|
|
To Single
Telephone Line
3 Automatic dial mode setting
When the power cord and the telephone line cord are connected, the unit will start detecting the dial mode (tone
or pulse). If you cannot dial and “ｶ ｲ ｾ ﾝ | ﾁ ｪ ｯ ｸ | ｴ ﾗ ｰ U 6 1 ” is displayed, change the dial mode setting. |
登録 選択 機能 |
|
|
1 2 3
4 5 6
7 8 9 | ストップ |
0
Changing the dial mode
Confirming the dial mode
1.Set the dial mode to “20”.
(See “Changing the dial mode” shown on the left.)
2. Dial 1 1 7 (time signal).
If you cannot dial, change to “10”.
If you cannot dial after changing to “10”, set to “ﾌ ﾟ ｯ ｼ ｭ ” (tone).
Note:
1.Press 機能 (function).
2.Press 
0 7 9 .
3.Press 選択 (select) to select the dial mode (ｶ ｲ ｾ ﾝ ｼ ｭ ﾍ ﾞ ﾂ ).
4.Press 登録 (record).
ストップ
5. Press 
(stop).
ｶ ｲ ｾ ﾝ ｼ ｭ ﾍ ﾞ ﾂ = ﾌ ﾟ ｯ ｼ ｭ
ｶ ｲ ｾ ﾝ ｼ ｭ ﾍ ﾞ ﾂ = 2 0
ｶ ｲ ｾ ﾝ ｼ ｭ ﾍ ﾞ ﾂ = 1 0
ｶ ｲ ｾ ﾝ ｼ ｭ ﾍ ﾞ ﾂ = ｼ ﾞ ﾄ ﾞ ｳ
Tone
Pulse 20pps
Pulse 10pps
Auto
If this unit is connected to a PBX or used as an extension, dial the access code (eg. 0 ) before the time signal.
2