ADVANCED OPERATION
PROGRAMMING YOUR ROBOPET™
YOU CAN PROGRAM A SEQUENCE OF UP TO 20 MOVES AND TRICKS USING THE CONTROLLER.
1) PRESS PROGRAM 
TO ENTER PROGRAM MODE. ROBOPET™ WILL MAKE A SMALL NOISE.
2)ENTER MOVEMENT AND TRICK COMMANDS AS USUAL.
A)FORWARD AND BACKWARD WILL MAKE ROBOPET™ MOVE FORWARD OR BACKWARD.
B)TURN LEFT AND TURN RIGHT WILL MAKE ROBOPET™ WALK AN ARC.
C)STOP WILL MAKE ROBOPET™ WAIT FOR 3 SECONDS.
D)YOU CAN ENTER TRICKS INTO A PROGRAM SEQUENCE, PRESS TRICKS A NUMBER OF TIMES AND PRESS EXECUTE TO CONFIRM THE CHOICE. (SEE TRICK SELECTION PAGE 6, EACH TRICK WILL BE COUNTED AS ONE PROGRAM STEP.)
3)EACH TIME YOU ENTER A COMMAND ROBOPET™ WILL MAKE A SMALL NOISE.
4)PRESS PROGRAM 
AGAIN TO FINISH PROGRAMMING AND MAKE ROBOPET™ PERFORM THE SEQUENCE.
5)IF YOU EXCEED 20 STEPS ROBOPET™ WILL MAKE A SMALL NOISE, PRESS
PROGRAM 
TO PERFORM THE PROGRAM.
6)TO REPEAT THE SEQUENCE PRESS PROGRAM 
THEN PRESS EXECUTE 
OR PROGRAM 
AGAIN. IF YOU ENTER ANY INSTRUCTIONS BEFORE PRESSING EXECUTE 
OR PROGRAM 
YOU WILL WRITE OVER THE OLD PROGRAM WITH THE NEW SEQUENCE.
ROBOPET™ WILL NOT STORE THE PROGRAM AFTER YOU TURN OFF THE POWER OR CHANGE THE BATTERIES, BUT THE PROGRAM WILL STAY IN MEMORY WHEN ROBOPET™ GOES INTO SLEEP MODE.
OBSTACLE AVOIDANCE, EDGE DETECTION AND FALL DETECTION WILL FUNCTION AS USUAL IN PROGRAM MODE. (SEE ROBOPET’S™ SENSORS ON PAGE 11, 12 & 13)
8