AeroComm user manual CL4424 User’s Manual Programming The CL4424 units

Page 19

CL4424 User’s Manual

4.3Programming The CL4424 units

1.Connect a CL4424 unit to the serial communications port on the PC.

2.Connect the power supply to the CL4424 unit. Make sure the Pwr LED is on.

3.Start the CL4424 Configuration Utility.

4.Select the COM Port that is connected to the CL4424 unit on the PC Settings section.

5.Select the Interface Baud Rate of the CL4424 unit. All CL4424 units are shipped with a default rate of 115,200 bps (unless units have been pre-configured to match specific serial settings). If the Interface Baud Rate of the CL4424 unit is changed as described in Section 4.2 Changing CL4424 Settings, then PC Setting Baud Rate must be set to the same Baud Rate to allow proper programming of the units.

6.Select the System Configuration for the CL4424 network, Point-to-Point(one Server and one Client) or Point-to-Multipoint(one Server and multiple Clients).

7.Select Read Radio to display the current settings of the CL4424 unit.

8.Change desired settings.

9.After all changes have been made, select Write Radio to save the changes.

10.Cycle Power to the unit after all changes has been saved. This will set the CL4424 unit to its normal mode of operation.

6/21/2005

19

Image 19
Contents CL4424 Document Information Limited WarrantyThis material is preliminary FCC Information FCC Notice RF Exposure/Installation InstructionsTable of Contents Overview FeaturesCL4424 RF Transceiver CL4424 User’s ManualSpecifications CL4424 CL4424 User’s Manual CL4424 SpecificationCL4424 Status LEDs CL4424 User’s Manual CL4424 InterfaceDescription RS-232 Pin Assignments RS-485 2-wire Half Duplex Terminal Block Pin AssignmentsPin Description CL4424 Mechanical Diagram CL4424 Mechanical DiagramInterfacing Protocol DTE Pin DTE SignalNull Modem Pin CL4424 User’s Manual RS-232CL4424 User’s Manual DCE to DCE Interface RS-485 2-wire Half DuplexCL4424 User’s Manual Hardware Flow Control Point-to-Point Network TopologiesPoint-to-Multipoint Installation CL4424 Configuration Utility SoftwareCL4424 Settings ConnexLink Settings US and International RF Channel Number SettingsRate setting of its host device PC Settings Optional SettingsAdditional Features CL4424 User’s Manual Programming The CL4424 units Problem Solution Troubleshooting