Linksys WET11 manual Appendix H Regulatory Information, FCC Statement

Page 48

Wireless-B Ethernet Bridge

Appendix H: Regulatory Information

FCC STATEMENT

This product has been tested and complies with the specifications for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used according to the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which is found by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

•Reorient or relocate the receiving antenna

•Increase the separation between the equipment or devices

•Connect the equipment to an outlet other than the receiver's

•Consult a dealer or an experienced radio/TV technician for assistance

FCC Caution: Any change or modification to the product not expressly approved by Linksys could void the user’s authority to operate the device.

FCC RF Radiation Exposure Statement

To comply with the FCC and ANSI C95.1 RF exposure limits, the antenna(s) for this device must comply with the following:

•Access points with 2.4 GHz or 5 GHz integrated antenna must operate with a separation distance of at least 20 cm from all persons using the cable provided and must not be co-located or operating in conjunction with any other antenna or transmitter.

End-users must be provided with specific operations for satisfying RF exposure compliance.

Note: Dual antennas used for diversity operation are not considered co-located.

Appendix H: Regulatory Information

43

Page 47 Page 49
Image 48
Page 47 Page 49
Contents 802 GHz .11b Wireless- B How to Use this Guide Copyright and TrademarksTable of Contents Wireless-B Ethernet Bridge Infrastructure Mode Ad-Hoc ModeIntroduction IntroductionWhat’s in this Guide? Wireless-B Ethernet Bridge Ad-Hoc versus Infrastructure Mode Network TopologyAd-Hoc Mode Getting to Know the Wireless-B Ethernet Bridge LANPWR Connecting the Wireless-B Ethernet Bridge for Setup Connect the Ethernet Network CableSetting Up the Wireless-B Ethernet Bridge Setup WizardOverview List of Bridges Wireless Settings WEP Key Connecting the Wireless-B Ethernet Bridge for Network Use Using the Wireless-B Ethernet Bridge Web-based Utility Starting the Web-based UtilitySetup WirelessSite Survey Password Tab Advanced MAC AddressLAN Settings Wireless SettingsStatus LAN StatisticsHelp Help TabAppendix a Troubleshooting Common Problems and SolutionsFrequently Asked Questions Web-based Utility doesn’t detect the BridgeWhat is ad-hoc mode? What is Spread Spectrum? Appendix B Wireless Security Brief OverviewWhat Are the Risks? Passive Attacks Jamming AttacksMaximizing Wireless Security Active AttacksDictionary-Building or Table Attacks Man-in-the-Middle AttacksWireless-B Ethernet Bridge Ssid Wireless-B Ethernet Bridge WEP Encryption Figure B-2 WEP EncryptionAppendix C Upgrading Firmware Appendix D Windows Help Shared ResourcesNetwork Neighborhood/My Network Places Appendix E Glossary Wireless-B Ethernet Bridge Wireless-B Ethernet Bridge Wireless-B Ethernet Bridge Wireless-B Ethernet Bridge Wireless-B Ethernet Bridge Appendix F Specifications ModelStandards Ieee 802.11b, Ieee Ports ButtonsWarranty Year Limited Operating HumidityStorage Humidity Appendix G Warranty Information Limited WarrantyAppendix H Regulatory Information FCC StatementIndustry Canada Canada Wireless-B Ethernet Bridge Appendix I Contact Information
Top Page Image Contents