Linksys USB300M manual Driver Installation for Windows Vista

Chapter 2

Configuration

11.Click the Power Management tab. Select Allow the computer to turn off this device to save power. Click OK to save the property settings.

Fast Ethernet Adapter Properties—Power Management tab

Congratulations! The installation of the USB Ethernet Adapter is complete.

For more information about networking under Windows XP or Windows 2000, refer to your Microsoft Windows XP or Windows 2000 documentation.

Driver Installation for Windows Vista

NOTE: Do not click Cancel at any time during the installation process. Doing so will prevent your driver from being properly installed on your computer.

1.If you have not yet done so, start your computer.

2.Connect the Adapter to your computer. Refer to Installing the Adapter, page 3.

3.Windows Vista will automatically detect the Adapter. When the Found New Hardware screen appears, insert the Installation CD into the CD-ROM drive. Then click Locate and install driver software (recommended).

Found New Hardware

4.The Driver Software Installation screen appears. When the screen displays the message The software for this device has been successfully installed, click Close. Then remove the Installation CD from the CD-ROM drive.

Driver Software Installation—Installing Device Driver

Driver Software Installation—Device Driver Installed