Linksys USB1000 manual Hardware Installation, Setup Being Performed

Page 11

Gigabit USB Adapter

3. The driver files will be copied onto your PC.

4.This screen will appear when the installation is complete. Click Finish to finish the installation. Click the Exit tab to exit the Utility.

Hardware Installation

1.Connect the USB Connector of the Gigabit USB Adapter to the USB port of your computer. Slide the connector out from it’s holder, unwind the cable, and connect the USB Connector to the USB port in your PC.

The Adapter will be automatically detected and installed by Windows. Your Windows operating system may require you to restart your computer to complete the installation.

2.Connect an Ethernet cable to the Ethernet port on the Adapter, then connect the other end to the Ethernet port on the switch or other networking device.

The setup is complete.

Chapter 3: Setup Utility for the Gigabit USB Adapter

Figure 3-5: Setup Being Performed

Figure 3-6: Installation Complete

7

Hardware Installation

Page 10 Page 12
Image 11
Page 10 Page 12
Contents Gigabit USB Adapter Copyright and Trademarks Table of Contents Front Panel’s LEDs Back PanelWelcome IntroductionWhat’s in this Guide? Front Panel Getting to Know and Connecting the Gigabit USB Adapter USB Icon and Ports Overview Setup Utility for the Gigabit USB AdapterSetup Utility Setup and Driver InstallationFile Location Setup Being Performed Hardware InstallationDriver Uninstallation Uninstalling the Driver10 Uninstallation Complete Common Problems and Solutions Appendix a TroubleshootingNetwork Neighborhood I can see myself but no other computers Appendix B Glossary Gigabit USB Adapter Gigabit USB Adapter Gigabit USB Adapter Gigabit USB Adapter Gigabit USB Adapter Gigabit USB Adapter FCC Statement Appendix C Regulatory InformationCE, FCC, Ices Appendix D SpecificationsLimited Warranty Appendix E Warranty InformationAppendix F Contact Information
Top Page Image Contents