![](/images/new-backgrounds/1266899/26689915x1.webp)
Chapter 2
Configuration
Power on a Device that Uses Inline Power
Use only the Injector to power up a device that supports inline power. Follow these instructions:
1.Connect the Injector’s
2.Connect the Kit’s included Ethernet network cable to the Injector’s Power & Data OUT port.
3.Then connect the other end to the Ethernet port of your remotely located access point or other network device.
NOTE: If the plug of the Splitter’s Power cord does not fit into your network device, then use the included barrel jack adapter. Plug the Splitter’s Power cord into the jack end, and plug the other end of the barrel jack adapter into the Power port of your network device.
4.Connect the Kit’s power adapter to the Injector, and plug the other end into an electrical outlet or surge protector.
Congratulations! The installation of the Power Over
Ethernet Kit is complete.
12 Volt Power Over Ethernet Adapter Kit | 5 |