Wireless-N Access Point with Power Over Ethernet
The Wireless - Wireless Connection Control Tab
This screen allows you to configure the Connection Control List to either permit or block specific wireless client devices connecting to (associating with) the Access Point.
Wireless Connection Control
Enabled/Disabled. Enable or disable wireless connection control. The default is disabled.
Connection Control
There are two ways to control the connection (association) of wireless client devices. You can either prevent specific devices from connecting to the Access Point, or you can allow only specific client devices to connect to the Access Point. The client devices are specified by their MAC addresses. The default is to allow only specific client devices.
Wireless Client List | Figure |
Instead of manually entering the MAC addresses of each client, the Access Point provides a convenient way to select a specific client device from the client association table. Click this button and a window appears to let you select a MAC address from the table. The selected MAC address will be entered into the Connection Control List.
Connection Control List
MAC
Change these settings as described here and click Save Settings to apply your changes, or click Cancel Changes to cancel your changes. Help information is displayed on the
Chapter 6: Configuring the
Figure 6-15: Select MAC Address from Wireless Client
List
24
The Wireless - Wireless Connection Control Tab