Wireless-N Notebook Adapter
Connect
The Connect screen displays a list of available networks in the table on the left. The table shows each network’s Wireless Network Name, Channel, and the quality of the wireless signal the Adapter is receiving. You may click Wireless Network Name, CH (Channel), or Signal, to sort by that field.
Wireless Network Name - The SSID or unique name of the wireless network is displayed here.
CH - This is the channel that the network uses.
Signal - This is the percentage of signal strength, from 0 to 100%.
Site Information
For each network selected, the following settings are listed:
Wireless Mode - This is the mode of the wireless network currently in use.
Network Type- This is the network type used by your wireless network.
Radio Band - This is the radio band used by your wireless network.
Security - The status of the wireless security feature is displayed here.
MAC Address- The MAC address of the wireless network’s access point is displayed here.
Refresh - Click the Refresh button to perform a new search for wireless devices.
Connect - To connect to one of the networks on the list, select the wireless network, and click the Connect button. If the network has encryption enabled, then you will see a new screen appear.
•If the network has the wireless security WEP encryption enabled, then you will see the WEP Key Needed for Connection screen. Select the appropriate level of WEP encryption,
•If the network has the wireless security PSK security enabled, then you will see the
PSK for Connection screen. Select the appropriate encryption type, TKIP or AES. Enter the network’s Pre- shared Key in the
Chapter 5: Using the Wireless Network Monitor
Figure 5-6: WEP Key Needed for Connection
Figure 5-7: PSK Needed for Connection
Figure 5-8: PSK2 Needed for Connection
20
Connect