Chapter 3
Advanced Configuration
Status > Bridge
The Bridge’s current status information is displayed.
Status > Bridge
Bridge Information
Firmware Version The Bridge’s current firmware is displayed.
Local Network
Local MAC Address The Bridge’s MAC Address, as seen on your local, Ethernet network, is displayed.
IP Address The Bridge’s IP Address, as seen on your local, Ethernet network, is displayed.
Subnet Mask The Subnet Mask configured for your local network is displayed.
Status > Wireless
Information about your wireless network is displayed.
Status > Wireless
Wireless
Link Status The status of the connection to your wireless network is displayed.
MAC Address The Bridge’s MAC Address, as seen on your local, wireless network, is displayed.
Network Name (SSID) The wireless network name or SSID is displayed.
BSSID The wireless MAC address of the connected wireless router (or access point) is displayed.
Radio Band The radio band of your wireless network is displayed.
Channel Width The channel width, in MHz, used by your wireless network is displayed.
Wide Channel Depending on the channel settings of your network router, the Wide Channel is displayed. If you selected Wide - 40MHz Channel for the router’s Radio Band or Channel Width setting, then this will be your primary
Standard Channel The Standard Channel setting is displayed. If you selected Wide – 40MHz Channel for the router’s Radio Band or Channel Width setting, then the Standard Channel will be a secondary channel for
Bit Rate The data transmission rate is displayed.
Signal The percentage of signal strength is displayed. 100% is the strongest signal strength possible; 0% is the weakest possible.
Security The security method of your wireless network is displayed.
Status > About
Information about the
Status > About
Web Server
Powered By The web server of the
11 |