Installing Your CABLE-NOOK Jr, Operation

DESIGNER SOLUTIONS

INSTALLING YOUR CABLE-NOOK Jr.™ 6

Step 1. Cut an opening in the table’s surface. Refer to www.altinex.com for table cutout dimensions and templates. The tabletop thickness must be 3 inches [76mm] or less.

Always confirm dimensions before cutting the table to ensure that the specifications have not changed.

Step 2. Adjust the bracket mounts inside the unit to suit your needs. CAUTION! Do not handle the unit by the bezel’s thin lip or lay it on it’s side on the lip. The thin bezel lip is very sharp and can be easily dented or bent. Handle the unit by the housing portion only. Remove the two screws securing each bracket to the interior housing if necessary to place them at the level that you require using the holes on the side of the housing. Replace the screws on each bracket mount after making sure that they are at exactly the same level.

Step 3. Insert the Cable-Nook Jr.™ unit into the tabletop cutout. Place a mounting bracket with the thumbscrew installed into the support mounts on each side of the housing as shown in Figure 1. With the mounting brackets installed, turn the thumbscrews until the ends of the screws begin to push against the bottom of the table. Tighten the screws until the unit is secure. Do not over-tighten.

OPERATION

Lift the Cable-Nook Jr.™ ’s cover to install or route cables. If the cables need to be connected while the lid is closed, route the cables through the open space in the front of the lid. Unconnected cables may be stored inside the Cable-Nook Jr.™. until they are needed.

Figure 1: Securing the Cable-Nook Jr.™ to the tabletop.

SUPPORT MOUNTS

TABLETOP

SUPPORT BRACKET

THUMBSCREW

SUPPORT MOUNTS

HOUSING