D-Link DFM-560EL manual

Page 35

D-Link DFM-560EL External Modem	User’s Guide

31.Enable all the Hardware Features and select 115200 from Initial speed(bps) list, then click OK.

32.Click on the Server tab and enable three options of TCP/IP, Enable software compression and Enable PPP LCP extensions.

35

Image 35

Contents User’s Guide 56K V.92 ModemFCC Requirements Modem Commands Table of Contents Introduction Specifications SpecificationsHardware Installation Windows 95 B OSR2 Software InstallationClick Finish to end this installation procedure Click Other Locations… to install from the installation disk Link DFM-560EL External Modem User’s Guide Windows Page Page Link DFM-560EL External Modem User’s Guide Page Windows ME Page Link DFM-560EL External Modem User’s Guide Page Windows NT4.0 Page Page Page Page Page Page Click Yes restart Windows NT Page Page Select Point-to-Point Protocol PPP and click Next Page Page Link DFM-560EL External Modem User’s Guide Page Click Dial to connect to Page Windows Page Page Windows XP Page Windows 95/98/ME DiagnosticsPage Windows Page Windows XP Page Page Page Uninstalling Select D-Link DFM-560EL External Modem. then click Remove Select D-Link DFM-560EL External Modem then click Remove Windows NTPage Windows Select Uninstall\ Unplug a device, then click Next Link DFM-560EL External Modem User’s Guide Page Windows XP Page Page Page Troubleshooting Typing Commands CommandsDisconnect Hang-up AT CommandsSr=n Set Register r to n Register DefinitionsLimited Warranty What You Must Do For Warranty Service Wichtige Sicherheitshinweise Trademarks CE Mark Warning