D-Link DFE-500TX manual Hiya, Heading

DFE-500TX Ethernet PC Card User's Guide

5.Remove the DFE-500TX Software Diskette from your station's (the primary station's) diskette drive, and insert it into an available drive of a second station on your LAN. At the DOS prompt (here shown as >), key in:

>A: \DIAG\DIAG500.EXE

and <RETURN>. The opening screen of the Verification/Diagnostic program will appear onscreen at the second station. Key <RETURN> to bring up the Configuration Data and Diagnostic Menu onscreen at the second station. Follow the cues at the foot of the screen to select and run the Network Diagnostic program at the second station. The second station then begins broadcasting test packets, and at the same time is also ready to receive and return test signals transmitted from the primary station’s newly installed DFE-500TX.

7.Return to the primary station and follow the cues at the foot of the screen to select and run the Network Diagnostic program. Observe the “Packets Transmitted” and “Packets Received” lines to see that they track together (always show equal count numbers), which verifies normal network operation.

Hiya, Normal!

Hiya, Heading 1!

Hiya, Heading 2!

Most likely causes of failure in any of the verification/diagnostic tests are incorrect option settings, option settings that conflict with the settings of

14