Asus P5VDC-MX manual Front panel audio connector 10-1 pin Fpaudio

10 . Front panel audio connector (10-1 pin FP_AUDIO)

This is an interface for the front panel audio cable that allows convenient connection and control of audio devices.

By default, the pins labeled LINE_OUT_R/BLINE_OUT_R and the pins LINE_OUT_L/BLINE_OUT_L are shorted with jumper caps. Remove the caps only when you are connecting the front panel audio cable.

P5VDC-MX

AGND +5VA BLINE OUT R BLINE OUT L

FP_AUDIO
MIC2	MICPWR Line out R	NC	Line out L

P5VDC-MX Front panel audio connector

11 . Chassis intrusion connector (4-1 pin CHASSIS)

This connector is for a chassis-mounted intrusion detection sensor or switch. Connect one end of the chassis intrusion sensor or switch cable to this connector. The chassis intrusion sensor or switch sends a high-level signal to this connector when a chassis component is removed or replaced. The signal is then generated as a chassis intrusion event.

By default, the pins labeled “Chassis Signal” and “Ground” are shorted with a jumper cap. Remove the jumper caps only when you intend to use the chassis intrusion detection feature.

P5VDC-MX

CHASSIS

+5VSB MB Chassis Signal GND

(Default)

P5VDC-MX Chassis intrusion connector

1 - 32 Chapter 1: Product introduction