Asus VW 196 manual Detaching the arm/stand For Vesa wall mount

Page 12

2.2Detaching the arm/stand

(for VESA wall mount)

The detachable stand of the VW196/VW193/VW171 Series LCD monitor is specially designed for VESA wall mount.

To detach the arm/stand:

1.Remove the arm cover.

2.Have the front of the monitor face down on a table.

3.Use a screwdriver to remove the three screws on the stand of the monitor as the below drawing shows.

4.Detach the arm from the monitor.

•We recommend that you cover the table surface with soft cloth to prevent damage to the monitor.

•Hold the stand of the monitor when you remove the screws.

screws

The VESA wall mount kit (100 mm x 100 mm) is purchased separately.

2-	Chapter 2: Setup

Image 12

Contents User Guide Table of contents Federal Communications Commission Statement Canadian Department of Communications StatementSafety information Care & Cleaning Following symptoms are normal with the monitorConventions used in this guide Where to find more information Asus websites Optional documentationPackage contents WelcomeAssembling the monitor base Monitor introduction Front of the LCD monitorRear connectors from left to right Rear of the LCD monitorAdjusting the monitor Detaching the arm/stand For Vesa wall mount How to reconfigure OSD On-Screen Display menuOSD Function Introduction SplendidImage ColorSystem Setup Input SelectSpecifications summary ModelTroubleshooting FAQ Problem Possible SolutionVW196/VW193/VW171 Supported Operating modes IBM modesMAC modes