Carson SA-400-73 28V, SA-400-73 PG manual Service, Return, Problems, Symptom Possible Cause Check

Page 7

SERVICE

This unit is designed to provide years of reliable service under even the worst conditions. Many times there may appear to be a problem with the unit when the true problem is in the speaker(s) or improper installation. The following chart shows typical symptoms and possible causes.

A blown rear panel fuse doesn't necessarily mean that the unit is bad. If a speaker or speaker lead is shorted this fuse will blow before the unit is damaged. Disconnect the SPKR leads and replace the fuse. If the siren emits a sound when in the Yelp position it is OK. Check the speaker(s) or leads for possible shorting.

PROBLEMS

Symptom

Possible Cause

Check

No Power or siren output

Power switch not turned on

Does backlighting come on?

 

Bad Speaker

Do you hear a “pop” when turned on?

 

Connector or connections loose

With siren on, yelp selected, listen for tone in

 

Rear panel fuse blown

amplifier.

 

Loose connection at power source

Is an external fuse or circuit breaker used?

 

 

Are the power leads connected to a good buss?

No siren tone –

High Voltage Protection

The input voltage must be less than highest rating.

PA works

Mic Button stuck

Does Mic Button release properly?

No PA

PA volume not set properly

Try turning the PA volume control.

 

Function switch in Radio

PA is not available in Radio position.

Distorted siren sound

Speaker assembly loose

Is the speaker bell or tip loose?

 

Intermittent Aux Input connection

Is the Aux Input used and wired properly?

 

Low Vehicle voltage

The input voltage must be greater than lowest rating.

Intermittent siren tone

High Voltage Protection

Is the vehicle voltage regulator working properly?

 

Connector loose

Is the connector tight on the back of the unit?

 

Loose connection at power source

Check for loose leads back to power source.

 

Mic Button activation

Is something lying on the microphone?

 

Circuit breaker in supply

Is a circuit breaker used with at least 50A rating?

 

connection

 

Horn or manual stuck on

Siren switch stuck

Does the Siren pushbutton switch return fully when

 

Aux Input improperly connected

released?

 

 

Is the Aux Input used and wired properly?

No Radio

Unit not connected to a radio

Is the radio connected properly to the unit?

 

Radio volume too low

Can you hear the radio in the vehicle?

 

 

Try adjusting the internal radio volume control.

RETURN

If you have any questions concerning this or any other Carson product, please contact our Technical Service Department at (888) 577-6877. Many issues can be handled over the phone. We can also be reached via e-mail at service@carsonsirens.com

If a product must be returned for any reason, please contact our Technical Service Department to obtain a Returned Merchandise Authorization number (RMA#) before you ship the product to Carson. Please write the RMA# clearly on the package near the mailing label. Be sure to provide a return address, contact and phone number, along with a brief description of the problem.

TB0322B

Page 7 of 8

10/18/03

Image 7
Contents Technical Bulletin Operating Temperature Input PowerSiren Mode Output Power Audio Mode Output PowerSafety Precautions InstallationMounting Electrical Connections Wiring Harness ConnectionsOperation Power Output Adjust Radio Volume AdjustReturn ServiceProblems Symptom Possible Cause CheckDescription Parts