Asus manual Serial ATA 6.0 Gb/s connectors 7-pin SATA6G 1~7, F2A85-M Sata 6.0Gb/s connectors

9.Serial ATA 6.0 Gb/s connectors (7-pin SATA6G 1~7)

These connectors are for the Serial ATA 6.0 Gb/s signal cables for Serial ATA hard disk drives and optical disc drives. If you installed Serial ATA hard disk drives, you can create a RAID 0, RAID 1, RAID 5, RAID 10, or JBOD configuration through the

onboard controller.

SATA6G_7

GND

RSATA_TXP7

RSATA_TXN7

GND

RSATA_RXN7

RSATA_RXP7

GND

SATA6G_5

GND RSATA_RXP5 RSATA_RXN5 GND RSATA_TXN5 RSATA_TXP5 GND

SATA6G_6

GND RSATA_RXP6 RSATA_RXN6 GND RSATA_TXN6 RSATA_TXP6 GND

F2A85-M

SATA6G_3						SATA6G_4
	GND RSATA_RXP3	RSATA_RXN3	GND RSATA_TXN3	RSATA_TXP3	GND	GND RSATA_RXP4	RSATA_RXN4	GND RSATA_TXN4	RSATA_TXP4	GND
SATA6G_1						SATA6G_2
	GND RSATA_RXP1	RSATA_RXN1	GND RSATA_TXN1	RSATA_TXP1	GND	GND RSATA_RXP2	RSATA_RXN2	GND RSATA_TXN2	RSATA_TXP2	GND

F2A85-M SATA 6.0Gb/s connectors

•These connectors are set to AHCI mode by default. In AHCI mode, you can connect

Serial ATA boot/data hard disk drives to these connectors. If you intend to create a Serial ATA RAID set using these connectors, set the type of the SATA connectors in the BIOS to [RAID]. See section 2.5.2 SATA Configuration for details.

•You must install Windows® XP Service Pack 3 or later version before using Serial ATA hard disk drives. The Serial ATA RAID feature is available only if you are using Windows® XP SP3 or later version.

•When using hot-plug and NCQ, set the type of the SATA connectors in the BIOS to [AHCI]. See section 2.5.2 SATA Configuration for details.

1-30 Chapter 1: Product introduction