Bottom Panel, Fuse | Crate Amplifiers VTX212 instruction

VTX212 Three-Channel Guitar Amplifier with Advanced DSP

The Bottom Panel:

CAUTION

RISK OF ELECTRIC SHOCK

DO NOT OPEN

AVIS: RISQUE DE CHOC ELECTRIQUE.

NE PAS OUVRIR.

WARNING: TO REDUCE THE RISK OF FIRE

OR ELECTRIC SHOCK, DO NOT EXPOSE THIS

EQUIPMENT TO RAIN OR MOISTURE.

FUSE

100VAC: T2.5A	250V
120VAC: T3A	250V
230V/240VAC: T1.6A		250V

MADE IN CHINA

FOR SLM ELECTRONICS

1400 FERGUSON AVE. ST. LOUIS, MO 63133 PATENT #5,032,796

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation.

EXTENSION		FOOTSWITCH

SPEAKER	DSP		CHANNEL
	BANK A		CLEAN
	BANK B		SOLO/RHYTHM

#3031613

INSERT

27:FUSE: The fuse protects the amplifier from damages caused by a faulty AC power source and/or other prob- lems. If the fuse opens, replace it ONLY with the same size and type. If fuses continue to fail, check the AC source

– if the source is okay, contact your Crate dealer for service information.

28:EXTENSION SPEAKER: Use this jack to connect the amplifier to an external speaker cabinet. This jack is wired in series with the internal speaker(s) which remain active when an extension speaker is connected.

29:DSP A/B FOOTSWITCH: Use this jack to connect one of the footswitch cables to the three-button footswitch (supplied). This allows you to select between two presets for each of the three channels. Additional information about the operation of the footswitch is on page 9.

30:CLEAN/SOLO/RHYTHM FOOTSWITCH: Use this jack to connect one of the footswitch cables to the three- button footswitch (supplied). This allows you to remotely switch between the Clean and Distortion channels and between the Solo and Rhythm channels. (See page 9.)

31:INSERT: Use this jack to connect an external signal processor to the amplifier. Use Crate’s STP201, STP202, or STP203 stereo-to-mono Y-cord or an adapter such as Crate’s YPP117 and two 1/4” mono signal cables to con- nect to the effect as shown below.

32:AC LINE CORD (not shown): This grounded power cord is to be plugged into a grounded power outlet, wired to current electrical codes and compatible with the voltage, power, and frequency requirements stated on the bot- tom panel. Do not attempt to defeat the safety ground connection.

Stereo-to-mono Y-cord:

Y-adapter and 2 cables:

	to Insert	TIP	RETURN	TIP	to Insert
	jack	RING	SEND	RING	jack
		SLEEVE	GROUND	SLEEVE
	(STP201, 3'			(YPP117)
	STP202, 6'			(YPP117)
	STP203, 9')
				TIP	RING
	TIP		RING
				(1/4"-TO-1/4"
				MONO SHIELDED
				CABLES)
	to	to		to	to
	effect	effect		effect	effect
	"OUT"	"IN"		"OUT"	"IN"
	jack	jack		jack	jack
6	External Effect			External Effect