Dell AMP01 manual Technical Specifications, Drives SAS hard drives

Page 10

Technical Specifications

Drives

SAS hard drives	up to 15 1-inch-by-3.5-inch SAS hot-plug hard drives (3.0 Gbps)
	at speeds of 10K or 15K rpm (See your system readme file for
	supported disk capacities.)
SATA hard drives	up to 15 1-inch-by-3.5-inch SATA hot-plug hard drives (3.0 Gbps)
	at speeds of 7.2K rpm. Connectivity to the system backplane is
	provided through an interposer assembly.

Connectivity

Configurations	support for either of the following configurations:
	• unified mode for direct connectivity to 15 hard drives
	• split mode with dual EMMs providing a direct connectivity to
	drives 0 though 6 and a separate direct connectivity to drives 7
	though 14

Enclosure Management Modules

EMMs	1 or 2 modules
Sensors	1 sensor per EMM

Backplane Board

Connectors	• 15 SAS hard-drive connectors
	• 2 power supply/cooling fan module connectors
	• 2 sets of EMM connectors (6 connectors each EMM)
	• 1 control panel connector for front LEDs and enclosure mode
	switch
Sensors	2 temperature sensors

Back-Panel Connectors

SAS connectors (per EMM)	• 1 SAS "IN" connector for connection to the host
	• 1 SAS "OUT" connector for expansion to an additional enclosure
Serial connector (per EMM)	1 6-pin UART mini-DIN connector (for factory use only)

8

Getting Started With Your System

Image 10

Contents

Getting Started With Your System Page Getting Started With Your System June HK192 System Features Other Information You May Need Installing the Rails and System in a Rack Unpacking the SystemConnecting the Power Cables Attaching the Power Cord Retention BracketInstalling the Bezel Turning on the SystemTechnical Specifications Drives SAS hard drivesEMM BTU per hour 1430 Getting Started With Your System Guide de mise en route Remarques, avis et précautions Caractéristiques du système Autres informations utiles Installation des rails et du système dans un rack Connexion des cordons dalimentation Fixation du support du cordon dalimentationInstallation du cadre Mise sous tension du systèmeCaractéristiques techniques Lecteurs Disques durs SASEMM et un affichant létat du module EMM Guide de mise en route Primeiros passos Com o sistema Notas, avisos e cuidados Recursos do sistema Como obter assistência técnica Instalação e configuração Outras informações úteisRemoção do sistema da embalagem Instalação dos trilhos e do sistema no rackConexão dos cabos de alimentação Como conectar o suporte de retenção do cabo de alimentaçãoComo ligar o sistema Instalação do painelEspecificações técnicas Unidades Unidades de disco rígido SASContínua máxima pico de 550 W Primeiros passos com o sistema Procedimientos iniciales Con el sistema Notas, avisos y precauciones Características del sistema Obtención de asistencia técnica Instalación y configuración Otra información necesariaDesembalaje del sistema Instalación de los rieles y del sistema en un rackConexión de los cables de alimentación Fijación del soporte de retención del cable de alimentaciónEncendido del sistema Instalación del embellecedorEspecificaciones técnicas Indicadores LED de estado de dos colores, uno para cada uno Procedimientos iniciales con el sistema

Related manuals

Manual 102 pages 37.17 Kb