Model
2.3 Configuration for Composite Video and Stereo Audio
The
For normal operation (VGA or YPbPr), J1 and J2 on the rear of the unit, are installed. For transmitting composite video and audio, you need to remove or cut these jumpers.
An HD15 to 3 RCA cable will be required. The composite video is sent on the green (pin 2), and the light and left audio channels are sent on the Red (pin 1), and Blue (pin 3). Note that some cables may have Yellow (video), Red (right audio), and White (left audio) RCA connectors instead of RGB connectors.
NOTES
If the length of Cat5 Cable is longer than 300 feet you may need to attach a power supply to the receiver unit. Generally if the remote display device is referenced to ground (i.e. the VGA connector ground or case, is connected to power line ground) you should not need an additional power supply to the specified maximum length of 500 feet
Do not connect this unit to any LAN device such as network cards or hubs as this may damage the AC155A and/or the LAN device. Use EIA/TIA 568B standard
8