Chapter 3: Installation
3. Installation
1. Connect the SHDSL line to the DSL
Pin 4 and Pin 5 for SHDSL line
Figure 3-1. RJ-48 connector, Pins 4 and 5.
2.Connect the Ethernet interface to the RJ-45 port with the included CAT5 cable.
3.Connect the included power cord to the AC outlet.
CAUTION: Verify that the
NOTE: The Interconnecting cables should be rated for external use and for the application’s voltage, current, anticipated temperature, flammability, and mechanical serviceability.
4.Turn on the power switch. Set one G.SHDSL Two-Wire Ethernet Network Extender as CO (master) site from console port, and the other as remote (slave) site.
5.Set the desired data rate for the SHDSL connection from the console port.
NOTE: Both G.SHDSL
6. Both G.SHDSL Two-Wire Ethernet Network Extenders will automatically connect with each other.
NOTE: Turn on the power switch, and
Page 11