Black Box LGC200A manual Installation Typical Installation 1 LGC201A and LGC202A

Page 18

Chapter 4: Installation

4. Installation

4.1 Typical Installation

4.1.1 LGC201A and LGC202A

1.The SC fiber connector of an LGC201A transmits/receives data by 850-nm short-wave laser on multimode fiber.

2.The SC fiber connector of an LGC202A transmits/receives data by 1310-nm short-wave laser on single-mode fiber.

Figure 4-1 shows a typical installation.

Device A		Twisted-pair		Twisted-pair Device B
		cable		cable

LGC201A					LGC201A

or					or
LGC202A					LGC202A

Multimode or single-mode fiber optic cable

Figure 4-1. Transmits and receives data on multimode or single-mode fibers.

NOTE: The units work in pairs. You have to use either two LGC201A converters or two LGC202A converters. Or use two kinds of SFP modules, single-mode or multimode.

Page 18

724-746-5500 blackbox.com

Image 18

Contents Pure Networking Gigabit Media Converters Trademarks Used in this Manual Trademarks Used in this ManualFCC and IC RFI Statements Normas Oficiales Mexicanas NOM Electrical Safety Statement NOM StatementNOM Statement Table of Contents Specifications SpecificationsFeatures OverviewOverview Introduction Connectors and Network Cables Supported What’s IncludedHardware Description 1 LGC201APWR LED 2 LGC202A Front panel of the LGC202ATX/RX 3 LGC200A Front panel of the LGC200ALGC200A components Configuration ConfigurationApplication using one media converter Installation Installation Typical Installation 1 LGC201A and LGC202A2 LGC200A Plug the SFP module into the LGC200A Device aInstallation Procedure Install the Media Converter into the LHC200A-RACKInstalling a media converter into the chassis Installation Operation Operation LEDs on the Media ConvertersForce/Auto Switch OFFTroubleshooting Troubleshooting Contacting Black BoxShipping and Packaging Blackbox.com Blackbox.com Chapter About Black Box