6
SAMSUNG DVM-Pro User Guide
03
Cad mode Procedure for using
Explain
This is cad mode procedure for using when design the new project. This procedure is not included modify procedure.
01Project Registration
02Space management
03Clean architectural
drawing layers
04Add In/outdoor
05In/Outdoor connection
06Pit drawing
07Pipe drawing
08System check
09Control lines
drawing
•Add the floor in the space management windows
•Specify the floor boundary
•When design
•When add indoor, The area recognized the room and it will be added room Automatically.
•It can continue to draw level that all of indoor and outdoor unit must be a connection.
•After select in in/outdoor connection windows, you can drawing outdoor.
•Select the pit in the pit drawing window, you can draw multiple outdoor pit.
•It can draw the pipe through Draw pipe/pipe accessories, Draw communication wires/wired remote controller.
•It can connected main pipe to multiple indoor at once, automatically Through Draw piping automatically, Draw drain pipe automatically
•Refrigerant pipe connection , pipe length and pipe level difference etc is checked.
•When system check is error, modify the part of guided in
system check and check again.
•Drain pipe connection is checked.
•the end of the system check, pipe diameter is placed automatically.
•If click on the indoor to indoor, Communication wires and wired remote controller can connected by a line.
10Piping remarks &
Piping Diagram
11Control Diagram
•Insert the pipe remarks
•Insert piping diagram by click on the list in order on the piping diagram field of report.
•Insert control diagram by click on the list in order on the control diagram field of report.
SAMSUNG