Samsung Connecting Your Projector to PC: A Guide for SP-H03 Users

• The setup process might vary depending on your type of computer or version of Windows.  (For example, [Properties] appears instead of [Properties (R)] as shown in 1.)

•This projector supports 32 bit color quality (per pixel) when it is used as a PC monitor.

•Projected images may differ from the images on your monitor depending on the monitor manufacturer or Windows version.

•When connecting the projector to a PC, make sure that the PC setup complies with the display settings supported by this projector. If it does not, you may have signal problems.

2-8-2. Connecting with a PC

PC IN AV IN

RGB

Make sure that your PC and projector are turned off.

1.Insert the D-Sub gender adaptor into the [PC IN] slot on the back of the projector.

2.Connect a D-Sub cable to the D-Sub gender adaptor.

3.Connect the D-Sub cable to the RGB port on the PC.

Refer to "PC Timing (D-Sub)" in the "Supported Display Modes" section for information on supported input signals.

4.Plug in the power cords of the projector and the PC.

D-Sub cables are sold separately.

Using the Projector

1. Turn on the projector and select <Input Source> <PC>.

If the <PC> mode cannot be selected, check that the D-Sub cable and gender adaptor are connected correctly.

2.Turn on the PC, and then set the PC Environment (screen resolution, etc.) if necessary.

3.Adjust the screen.

Installation and Connection 2-8