[Appendix 3] Factory Reset
1.Default setting after factory reset
-Activate DHCP mode
-Local Port: 9100
-Inactivity Time: 0
-Speed
2.How to rest
1)Turn off the printer
2)Turn on the printer while pressing Function Key
[Note]
Press Function key 3 more seconds after turning on the printer.
3)Wait 10 seconds until new IP address is allocated to the printer.
-The IP address will be allocated automatically under DHCP mode.
[Note]
- DHCP Network environment
Connect to
Check new IP address by pressing Function key
- Static IP Network environment
The IP address will not be allocated automatically.
Set up Static IP with Configurator utility.
4)Print Network setting information by pressing Function key
-Connect
[Note]
Check if the baud rate of the printer is set same as below.